Cabletron Systems SmartSwitch manual Rmon CLI Filters

Chapter 21: RMON Configuration Guide

To display the RMON 2	rmon show address-map <port-list>all-ports
Address Map table.
To show Network Layer Host	rmon show nl-host<port-list>all-ports [summary]
logs.
To show Application Layer	rmon show al-host<port-list>all-ports [summary]
Host logs.
To show Network Layer	rmon show nl-matrix<port-list>all-ports [order-by
Matrix logs.	srcdstdstsrc] [summary]
To show Application Layer	rmon show al-matrix<port-list>all-ports [order-by
Matrix logs.	srcdstdstsrc] [summary]
To show all Network Layer	rmon show nl-matrix-top-n
Matrix Top N.
To show all Application	rmon show al-matrix-top-n
Layer Matrix Top N.
To show all user history logs.	rmon show user-history
To show probe configuration.	rmon show probe-config [basic] [net-config] [trap-
	dest]

1To display Ethernet statistics and related statistics for WAN ports, RMON has to be activated on that port. To activate RMON on a port, use the frame-relay define service or

pppdefine service command, and the frame-relay apply service or ppp apply service command. For addional information, refer to “Setting up a Frame Relay Service Profile” on page 324 (for frame relay) and “Setting up a PPP Service Profile” on page 328 (for PPP).

RMON CLI Filters

Because a large number of statistics can be collected for certain RMON groups, you can define and use CLI filters to limit the amount of information displayed with the rmon show commands. An RMON CLI filter can only be applied to a current Telnet or Console session.

SmartSwitch Router User Reference Manual 309