Campbell Manufacturing CR10 2718H, 3142J, Command Description, SECTION 5. TELECOMMUNICATIONS, TABLE 5.1-1.Telecommunications Commands

SECTION 5. TELECOMMUNICATIONS

TABLE 5.1-1. Telecommunications Commands

Command Description

[F.S. Area]A SELECT AREA/STATUS - If 1 or 2 does not precede the A to select the Final Storage Area, the CR10 will default to Area 1. All subsequent commands other than A will address the area selected. Datalogger returns Reference, the DSP location; the number of filled Final Storage locations; Version of datalogger; Errors #1 and #2 where #1 is the number of E08's and #2 is the number of overrun errors (both are cleared by entering 8888A; #2 is also cleared at time of program compilation); size of total Memory in CR10; Final Storage Area; Location of MPTR; and Checksum. All in the following format:

R+xxxxx Fxxxxx Vxx Exx xx Mxx Ax L+xxxxx Cxxxx

If data is stored while in telecommunications, the A command must be issued to update the Reference to the new DSP.

[no. of arrays]B BACK-UP - MPTR is backed-up the specified number of Output Arrays (no number defaults to 1) and advanced to the nearest start of array. CR10 sends the Area, MPTR Location, and Checksum: Ax L+xxxxx Cxxxx

[YR:DAY:HR:MM:SS]C RESET/SEND TIME - If time is entered the time is reset. If only 2 colons are in the time string, HR:MM:SS is assumed; 3 colons means DAY:HR:MM:SS. If only the C is entered, time is unaltered. CR10 returns year, Julian day, hr:min:sec, and Checksum: Y:xx Dxxxx Txx:xx:xx Cxxxx

[no. of arrays]D ASCII DUMP - If necessary, the MPTR is advanced to start of scan. CR10 sends the number of arrays specified (no number defaults to 1) or the number of arrays between MPTR and Reference, whichever is smaller, CRLF, Location, Checksum.

EEnd call. Datalogger sends CRLF only.

[no. of loc.]F BINARY DUMP - Used in TELCOM (PC208). See Appendix C.

[F.S. loc. no.]G MOVE MPTR - MPTR is moved to specified Final Storage location. The location number must be entered. CR10 sends Area, Location, and Checksum: Ax L+xxxxx Cxxxx

7H or 2718H REMOTE KEYBOARD - CR10 sends the prompt ">" and is ready to execute standard keyboard commands (Section OV3).

[loc. no.]I Display/change value at Input Storage location. CR10 sends the value stored at the location. A new value and CR may then be sent. CR10 sends checksum. If no new value is sent (CR only) the location value will remain the same.

3142J TOGGLE FLAGS AND SET UP FOR K COMMAND - Used in the Monitor Mode and with the Heads Up Display. See Appendix C for details.

5-3