8.Clear paper from all these areas by turning knobs as shown.

9.When all the paper is cleared turn on power shut the door make sure the jam light is out if not go back to step 1. And find the paper that is not clear.

10.When all the paper is cleared from the punch and the light is out follow the steps used above to clear the printer and finisher.

11.Hit the punch green button and then the resume button on the printer, operation should start.

12.If by chance you do not hit the green button the punch will go into bypass mode at this time you will have to hit the stop button on the printer hit the green button on the punch then the resume button on the printer.

13.This is only my way to clear a jam after you become more familiar with the punch this procedure can change to your own refinement.

4.10 SOFTWARE UPDATE PROCEDURE (VERSION 10)

SOFTWARE UPDATE PROCEDURE (Version 1.0)

Tools Required:

USB to DB9 female crossover cable.

Computer with USB port and Hyper Terminal Software

Download new firmware for installation and bootload.ht setup file.

Remove plastic cover from 9 pin connector on back of Professional Punch A1 Connect cable from computer to this 9 pin connector.

Run Hyper Terminal software.

From Hyper Terminal File Tab Open: bootload.ht

From Hyper Terminal Screen

Press ENTER Key on Keyboard

Press V for current software version number From Hyper Terminal Transfer Tab

Select Send Text File

Select new *.hex file to install

Numbers under the BOOTLOADER> prompt will increment as the download continues.

When finished, press V on keyboard to display the new version number Then press G on keyboard to install new software

When BOOTLOADER> prompt returns, the new software is installed. Disconnect cable

Restart Professional Puncher A1

31

Page 31
Image 31
Canon DU7-1175-000 service manual Software Update Procedure Version Tools Required