and the metal (w/o a belt) Green Belt Aligner Roller itself. Note that the two metal surfaces are flush.
Step 14: Remove the Green Belt Aligner Roller Assembly by removing the “4” screws (S).
Important: Leave the Flex Shaft (FS) attached.
Step 15: Stretch the new Belt (B) onto the Aligner Roller Assembly, green side out. Rotate the Shaft (S) to confirm that the belt tracks properly.
S
B
STRETCH
FS
Step 16: Slide the Aligner into place, loosely attach the “4” Pan Head Screws with the “4” Lock Washers.
Check that the metal surface of the Aligner Roller Assembly is flush with the Sheet Metal surface of the Paper Guide. A 12” metal ruler works well to check this adjustment. Slip the ruler under the green belt and press it flat against the two surfaces. Adjust the Aligner and snug the screws when perfectly flush.
NOTE: The green belt should look like the drawing shown after step 11.
As a double check, hold the entire Paper Guide assembly up so that you can visually inspect the alignment between the sheet metal surface and the metal surface of the Aligner. The Green Belt should appear to be even or parallel, and just floating above the surface of the sheet metal.
18
