As a double check, hold the entire Paper Guide assembly up so that you can visually inspect the alignment between the sheet metal surface and the metal surface of the Aligner. The Green Belt should appear to be even and just floating above the surface of the sheet metal.
ALIGN
& FIX SCREWS
Step 15: To install the Paper Guide Assembly into the Professional
ASSEMBLE BACK
A.As you slide the Paper Guide Assembly into place,
a.Hook up the Sensor Harness to the Sensor on the back.
b.Lift it up slightly to clear the lower Transition Paper Guide.
c.Be sure to clear the Sensor Bracket at the top left.
d.Be sure that the Flex Coupling Shaft is sticking out of the rear of the Professional
B.Visually check all around the mounting area of the Paper Guide Assembly and that the Sensor Harness is properly connected.
C.Loosely secure it in place with “3” screws on the left and “3” on the right.
D.Loosely install the “2” top screws. A useful tip might be to secure the Screw to the tip of your Screwdriver with a small piece of masking tape to assist you in finding the hole.
26
