Canon W7200, W7250 manual Print Media You Can Use

Note

zWhile roll media is loaded in the printer, avoid opening and closing the roll media tray. Opening and closing the tray causes the printer to cut the leading edge of the roll media and consume paper.

zYou should remove each sheet output to the output stacker, one at a time.

zBefore the printer is shipped from the factory, the Roll Media Type is set for Plain Paper.

zIt is recommended that the special settings (1 to 5) be used when smudges and blots appear on the print density is too light while printing on one of the media types listed above. The Special settings determine in 5 steps the amount of ink used on the surface of the media. The higher the number in the range of 1 to 5, the greater the amount of ink used. The setting may require testing and adjustment, depending on the media in use and the content of the image.

zThe media size is detected automatically, therefore no setting for the size is required.

zIn order to align the leading edge correctly on the W7200, the paper is fed approximately 100 mm (4 in.) then cut. On the W7250 without the stand installed, the paper is feed 300 mm (11.8 in.) then cut.

zWhen the optional stand is not installed with the W7250, pressing ￿ feeds the roll media only about 130 mm (5.1 in.) to ensure that the surface of the printing area is clean.

2-16

Print Media You Can Use