The table below lists the possible settings for the cut sheet type.

Media Name

Cut Sheet Type Setting

Plain Paper

Plain Paper

Coated Paper

Coated Paper

Heavy Coated Paper

Heavy Coated

Glossy Paper

Glossy Paper

Photo Glossy Paper

Photo Glossy

Photo Semi-Glossy Paper

Semi-Glossy

Glossy Film

Glossy Film

Back Print Film

Back Print Film

Proofing Paper

Proof

Special 1 to 5

Important

zA skew error occurs if the cut sheet is not straight. In this case, repeat the above procedure from Step 1 to set the cut sheet.

zYou must set the correct type of cut sheet. If the set cut sheet does not match the Cut Sheet Type setting, make the correct setting. (Æ P.2-24)

zYou should remove each sheet output to the output stacker, one at a time.

Note

z Before the printer is shipped from the factory, the Cut Sheet Type is set for Plain Paper.

z It is recommended that the special settings (1 to 5) be used when smudges and blots appear on the print density is too light while printing on one of the media types listed above. The Special settings determine in 5 steps the amount of ink used on the surface of the media. The higher the number in the range of 1 to 5, the greater the amount of ink used. The setting may require testing and adjustment, depending on the media in use and the content of the image.

z The media size is detected automatically, therefore no setting for the size is required.

Loading Cut Sheets

2-23

Page 49
Image 49
Canon W7250, W7200 manual Cut Sheet Type Setting