Projection Operations

To select the input source using remote controller keys

On the remote controller, press the [RGB], [VIDEO], or [S-VIDEO] key to select the input source you want.

zThe currently selected input source name is shown in the upper right corner of the projection screen.

zIf the currently selected input source is not sending an input signal, the message “No signal input” appears in place of the input source name.

zWhether the displayed input source name shows [RGB] or [Component] depends on the current “Input Settings J RGB Input” (page 89) setting that is configured on the

projector’s setup menu.

If the input source name shows this:

It means this input is selected:

RGB

RGB

 

 

Component

Component video

 

 

For information about configuring setup menu settings, see “Using the Setup Menu” on page 64. For information about component video, see “Connecting to a Component Video Output Device” on page 40.

49