Chapter 3 Troubleshooting 1240AG Series Autonomous Access Points
Low Power Condition
The< platform name> indicates the Cisco platform detected by the access point. The <MAC address> indicates the MAC address of the switch port.
Note You need to upgrade the software on the Cisco switch to support Intelligent Power
Management or configure the access point for
•
Caution When using the power inline negotiation injector override command, a power injector must always be installed to prevent a possible overload condition with an underpowered power source.
Configuring Power Using the CLI
Intelligent Power Management support is dependent on the version of software resident in the Cisco switch that is providing power to the access point. Each Cisco switch should be upgraded to support Intelligent Power Management. Until the software is upgraded, you can configure the access point to operate with older switch software using the following Cisco IOS CLI command:
[no] power inline negotiation {prestandard source injector {installed override H.H.H}}
(prestandard source indicates the Cisco switch does not support Intelligent Power Management. injector installed indicates a power injector is installed on the current switch port. injector override indicates a power injector is installed and the access point is configured to override the inline power checks. When you move the access point,
H.H.His used to specify the MAC address of the new switch port where the access point was moved. A MAC address of 0.0.0 is invalid.)
Caution When using the power inline negotiation injector override command, a power injector must always be installed to prevent a possible overload condition with an underpowered power source.
Note The power inline negotiation injector installed command will fail if CDP is disabled.
When using the power inline negotiation injector override command, you must use a power injector to prevent possibly overloading underpowered power sources.
You can use this Cisco IOS CLI command to inform the access point of the following:
•The Cisco switch does not support Intelligent Power Management but should be able to supply sufficient power.
•A power injector is being used to supply sufficient power and the Cisco switch does not support Intelligent Power Management.
•The access point was moved to a new Cisco switch port and a power injector is being used to supply sufficient power.
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
|
| ||
|
|
