Use the product control panel
Configure the TC/IP settings
You can configure the IP address manually or automatically.
Manual configuration
1.On the
2.Use the Left arrow ( 
) or the Right arrow ( 
) button to select Network config., and then press OK.
3.Use the Left arrow ( 
) or the Right arrow ( 
) button to select TCP IP config, and then press OK.
4.Use the Left arrow ( 
) or the Right arrow ( 
) button to select Manual, and then press OK.
5.Press the Right arrow ( 
) button to increase the value for the first section of the IP address. Press the Left arrow ( 
) button to decrease the value. When the value is correct, press OK.
6.If the address is correct, use the Left arrow ( 
) or the Right arrow ( 
) button to select Yes, and then press OK. Repeat step 5 for the subnet mask and default gateway settings.
If the IP address is incorrect, use the Left arrow ( 
) or the Right arrow ( 
) button to select No, and then press OK. Repeat step 5 to establish the correct IP address, and then repeat step 5 for the subnet mask and default gateway settings.
Automatic configuration
NOTE: Automatic is the default Network config. TCP IP config setting.
1.On the
2.Use the Left arrow ( 
) or the Right arrow ( 
) button to select Network config., and then press OK.
3.Use the Left arrow ( 
) or the Right arrow ( 
) button to select TCP IP config, and then press OK.
4.Use the Left arrow ( 
) or the Right arrow ( 
) button to select Automatic, and then press OK. It might take several minutes before the automatic IP address is ready for use.
NOTE: To disable or enable specific automatic IP modes (such as BOOTP, DHCP, or AutoIP), use the embedded Web server or HP ToolboxFX.
ENWW | Network configuration 25 |
