Cisco Systems 1503 Firmware Load and Restart Commands, Bootup Option Commands, bootup-option

Firmware Load and Restart Commands

Firmware Load and Restart Commands

Use the commands in this section to configure how the hub loads and copies firmware.

Bootup Option Commands

Use the commands in this section to configure how the hub gets the firmware and IP address when it is first powered up.

bootup-option

Syntax: bootup-option {normal tftp-download bootp-get-ip bootp-download}

Mode: Administrator

Description: Configures how the hub will obtain an IP address when it is first turned on.

This setting is stored in the hub Flash read-only memory.

Command Keyword Definitions

•normal—Default setting for the Micro Hub 1502. The hub uses the IP address stored in the onboard firmware.

•tftp-download—Downloads firmware from a TFTP server. The download process is repeated every time the hub is rebooted.

•bootp-get-ip—Default setting for the Micro Hub 1503. The hub obtains the IP address from the local BOOTP server.

•bootp-download—The hub obtains the IP address and firmware from a local BOOTP server. The firmware is then saved in Flash memory.

no bootup-option

Syntax: no bootup-option

Mode: Administrator

Description: Resets the hub to the default bootup option, which is to use the onboard ROM code and the default IP address (normal).

Using Your Hub Software 3-21