Cisco Systems 1503 manual Port Configuration Commands, Show port information

Port Configuration Commands

Port Configuration Commands

Use the commands in this section to display or edit information about any port in the stack.

show port information

Syntax: show port information [hub id]

Mode: Guest

Description: Displays information about all the network ports on the selected hub.

Command Keyword Definition

•hub id—(Optional) Number used to identify the hub in a stack. An integer between 1 and 5. Read the section “Hub ID Numbers” earlier in this chapter for information about how to determine hub ID numbers.

Information is displayed as follows:

Hub> show		port information	1
Hub id:	1
Port ID	Admin Status Link		Status	Partition Status

------------------------------------------------------

1	enabled	Not connected	not partitioned
2	enabled	Not connected	not partitioned
3	enabled	Connected	not partitioned
4	enabled	Not connected	not partitioned
5	enabled	Not connected	not partitioned
6	enabled	Connected	not partitioned
7	enabled	Not connected	not partitioned
8	enabled	Not connected	not partitioned

Command Display Definitions

•Hub ID—Number used to identify the hub in a stack. An integer between 1 and 5. Read the section “Hub ID Numbers” earlier in this chapter for information about how to determine hub ID numbers.

•Port ID—Number (1 through 8) of one of the yellow network station ports.

•Admin status—Whether or not the port has been manually disabled.

•Oper status—Whether or not the device connected to this port has a valid connection to the hub.

•Partition status—Whether or not the port has been partitioned by the hub, which usually happens as a result of a network loop.

Using Your Hub Software 3-37