Cisco Systems 1503 manual Management Configuration Commands, IP Parameter Commands

Management Configuration Commands

Management Configuration Commands

Use the commands in this section to configure community strings and trap managers, which are required when using SNMP.

IP Parameter Commands

Use the commands in this section to configure the Micro Hub 1503 with IP parameters. The hub must be configured with IP parameters to use SNMP, Telnet, and TFTP functions.

show ip configuration

Syntax: show ip configuration

Mode: Guest

Description: Shows the current configuration for IP, as shown below:

Hub> show ip configuration

IP address: 10.10.10.10

Subnet mask : 255.255.255.0

Gateway IP: 10.10.10.254

Command Display Definitions

•IP address—Hub’s IP address.

•Subnet mask—Hub’s subnet mask (the host address bits used for routing traffic to the subnet).

•Gateway IP—Gateway used to pass trap messages from the hub to the management stations, for example, the IP address of a router on the same LAN as the hub.

Using Your Hub Software 3-29