15-41
Cisco ONS 15454 Reference Manual, R7.0
78-17191-01
Chapter 15 Performance Monitoring
15.6 15.6.4 CE-Series Ethernet Card Performance Monitoring Parameters
15.6.4.5 CE-Series Card POS Ports Utilization Window
The POS Ports Utilization window shows the percentage of Tx and Rx line bandwidth used by the POS
ports during consecutive time segments. The Utilization window provides an Interval drop-down list that
enables you to set time intervals of 1 minute, 15 minutes, 1 hour, and 1 day. Line utilization is calculated
with the following formulas:
Rx = (inOctets * 8) / (interval * maxBaseRate)
Tx = (outOctets * 8) / (interval * maxBaseRate)
The interval is defined in seconds. The maxBaseRate is defined by raw bits per second in one direction
for the Ethernet port (that is, 1 Gbps). The maxBaseRate for CE-Series cards is shown in Table 15-14 on
page 15-31.
Note Line utilization numbers express the average of ingress and egress traffic as a percentage of capacity.
15.6.4.6 CE-Series Card Ether Ports History Window
The Ethernet POS Ports History window lists past Ethernet POS ports statistics for the previous time
intervals. Depending on the selected time interval, the History window displays the statistics for each
port for the number of previous time intervals as shown in Table 15-15 on page 15-31. The listed
parameters are defined in Table 15-20 on page 15-37.
gfpStatsTxFrame2Number of transmitted GFP frames.
gfpStatsRxCRCErrors Number of packets received with a payload FCS error.
gfpStatsRxOctets2Number of GFP bytes received.
gfpStatsTxOctets2Number of GFP bytes transmitted.
gfpStatsRxSBitErrors Sum of all the single bit errors. In the GFP CORE HDR at the GFP-T
receiver, these are correctable.
gfpStatsRxMBitErrors Sum of all the multiple bit errors. In the GFP CORE HDR at the GFP-T
receiver, these are uncorrectable.
gfpStatsRxTypeInvalid Number of receive packets dropped due to Client Data Frame UPI errors.
gfpStatsRxCIDInvalid1Number of packets with invalid CID.
gfpStatsCSFRaised Number of GFP Client signal fail frames detected at the GFP-T receiver.
ifInPayloadCrcErrors1Received payload CRC errors.
ifOutPayloadCrcErrors1Transmitted payload CRC errors.
hdlcPktDrops Number of received packets dropped before input.
1. Applicable only for CE100T-8
2. Applicable only for CE1000-4
Table 15-21 CE-Series Card POS Ports Parameters (continued)
Parameter Definition