Index
IN-9
Cisco ONS 15454 Reference Manual, R7.0
78-17191-01
remote monitoring (RMON) 16-16
Ethernet cards
see also CE-1000-4 card
see also CE-100T-8 card
see also E1000-2 card
see also E1000-2-G card
see also E100T-12 card
see also E100T-G card
see also G1K-4 card
see also ML1000-2 card
see also ML100T-12 card
see also ML100X-8 card
cross-connect card compatibility 2-5
factory defaults C-32
overview 5-2
path trace capability 11-24
performance monitoring 15-29
power requirements A-8
service disruption 1-14
software compatibility 5-3
specifications A-44
temperature range A-10
examples
1:N protection configuration 7-2
BLSR bandwidth reuse 12-9
BLSR ring switching 12-7
BLSR span switching 12-6
BLSR traffic rerouting following a fiber break 12-4
common fiber routing on a VCAT circuit 11-33
CTC and node on the same subnet (basic LAN
configuration) 13-3
CTC and nodes connected to a router 13-3
dual roll on the same circuit 11-41
dual roll with two circuits 11-41
five-node, two-fiber BLSR 12-9
foreign node connected to the DCC network 13-28
four-fiber BLSR fiber connections 12-12
four-fiber BLSRs 12-5
four-shelf node (fiber-optic bus) 12-21
GNE in a multivendor OSI network 13-50
G-Series Ethernet cards equiped with CWDM or
DWDM GBICs 5-34
integrated BLSR-DRI topology 12-16
IP-over-CLNS tunnel with a GNE endpoint 13-53
manual TARP adjacencies 13-39
nodes on the same subnet with secure mode (dual IP
addresses) enabled 13-21
OSI/IP European network 13-57
OSI GNE with an IP connection to the DCN 13-55
path-protected mesh networks 12-19
protocol flow in an IP-over-CLNS tunnel 13-43
Proxy ARP 13-5
remot enote connected to an ENE Ethernet port 13-28
roll from one circuit to another circuit at the
destination 11-40
SOCKS proxy server implementation 13-14, 13-15
split fiber routing on a CE-Series card VCAT
circuit 11-34
static routes 13-7
TCA raised on electrical ports 15-2
three-node linear ADM 12-19
traditional BLSR-DRI with opposite-side
routing 12-15
traditional BLSR-DRI with same-side routing 12-14
traffic pattern on a two-fiber BLSR 12-4
two-fiber BLSR 12-2
two-fiber BLSR fiber connections 12-12
unprotected configuration 7-14
extended fiber clips 1-6
external alarms and controls
see also AEP
see also AIC-I card
alarm contact connections 1-66
backplane connection location 1-11
description 2-29, 14-14
wire-wrap and pin connections 1-56
external firewalls 13-25
external switching commands 7-14
external timing 10-1