Cisco Systems 3650 manual Installing the Cisco Microsoft Windows USB Device Driver

Appendix C Configuring the Switch with the CLI-Based Setup Program

Accessing the CLI

Figure C-1 Connecting the USB Console Cable to the Catalyst 3650 Switch

344194

Step 2 Connect a USB cable to the PC USB port. Connect the other end of the cable to the switch mini-B (5-pin-connector) USB console port. See Figure C-1.

Step 3 Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC application such as HyperTerminal or ProcommPlus, makes communication between the switch and your PC or terminal possible.

Step 4 Configure the baud rate and character format of the PC or terminal to match the console port default characteristics:

•9600 baud

•8 data bits

•1 stop bit

•No parity

•None (flow control)

Step 5 Connect power to the switch as described in Chapter 3, “Power Supply Installation.”

Step 6 The PC or terminal displays the bootloader sequence. Press Enter to display the setup prompt. Follow the steps in the “Configuring the Setup Program” section on page C-5.

Installing the Cisco Microsoft Windows USB Device Driver

A USB device driver must be installed the first time a Microsoft Windows-based PC is connected to the USB console port on the switch.

To install the Microsoft Windows USB Device Driver:

Catalyst 3650 Switch Hardware Installation Guide

OL-29734-01 C-3