Cisco Systems 4900 Series manual Configure an enable password, and press Return

Appendix B Initial Configuration for the Switch

Entering the Initial Configuration Information

		The password can be from 1 to 25 alphanumeric characters, can start with a
		number, is case sensitive, allows spaces, but ignores leading spaces. The secret
		password is encrypted and the enable password is in plain text.
		Switch1 (config)# enable secret SecretPassword
	Step 9	Configure an enable password, and press Return.
		Switch1 (config)# enable password EnablePassword
	Step 10	Configure a virtual terminal (Telnet) password, and press Return.
		The password can be from 1 to 25 alphanumeric characters, is case sensitive,
		allows spaces, but ignores leading spaces.
		Switch1 (config)# password terminal-password
		Switch1 (config)# line vty 0 15
	Step 11	Configure the interface that connects to the management network. (The IP address
		and subnet mask shown are for example only. Use an address appropriate for your
		network.)
		Switch1 (config)# ip routing
		Switch1 (config)# interface gigabitethernet 24
		Switch1 (config-if)# no switchport
		Switch1 (config-if)# no shutdown
		Switch1 (config-if)#ip address 10.4.120.106 255.0.0.0
		Switch1 (config-if)# exit
	Step 12	Exit from global configuration mode:
		Switch (config)# exit
		Switch #
	Step 13	View the configuration you just created and confirm that it is what you want.
		Switch1# show run
		!
		hostname Switch1
		!
		banner motd ^C
		170 West Tasman Drive, San Jose, CA ^C
		!
		!--- Output suppressed.
	Step 14	Verify the IP information by using the show ip interface brief and show ip route
		commands.
		Switch1# show ip interface brief
	Catalyst 4900 Series Switch Installation Guide
B-6		78-18039-02