Cisco Systems 4900 Series manual Save the running configuration

Appendix B Initial Configuration for the Switch

Entering the Initial Configuration Information

Interface	IP-Address	OK?	Method	Status
Protocol
Vlan1	172.16.1.2	YES	manual	up
up
FastEthernet1	unassigned	YES	unset	up
up

!--- Output suppressed. Switch1# show ip route

Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B -

BGP

D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP

i- IS-IS, L1 - ISIS level-1, L2 - ISIS level-2, ia - ISIS inter area

* - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route

Gateway of last resort is 172.16.1.1 to network 0.0.0.0

	172.16.0.0/24	is subnetted, 1 subnets
C	172.16.1.0	is directly connected, Vlan1
S*	0.0.0.0/0 [1/0] via 172.16.1.1

Switch1#

Step 15 Save the running configuration:

Switch1# copy system:running-config nvram:startup-config

You have now completed the initial configuration of the switch.

To use the CLI to perform additional configuration or management tasks, enter commands at the Switch> prompt through the console port by using a terminal program or through the network by using Telnet. For configuration information, refer to the switch software configuration guide or the switch command reference.

	Catalyst 4900 Series Switch Installation Guide
78-18039-02		B-7