Cisco Systems 7507 quick start Copy the Configuration File for an RSP, Step Step Step

Enter the ping command followed by the name or IP address of the remote server, and then press Return to check the connection between the router and the remote host.

Enter the show running-configcommand to display the currently running configuration on the terminal and ensure that the configuration information is complete and correct. If it is not, use the configure command to add or modify the existing configuration.

Create a file on the TFTP server.

32

Install Field Replaceable Units (FRUs)

Copy the Configuration File for an RSP

Refer to the appropriate Cisco IOS software documentation for the configuration options available, and for specific configuration instructions, as needed.

Before you copy (save) the running configuration to a TFTP file server, ensure the following:

•You have a connection to the router either with a console terminal connected to the RSP console port or remotely through a Telnet session.

•The router is connected to a network supporting a file server (remote host).

•The remote host supports the TFTP application.

•You have the interface processor address or name of the remote host available.

Step 1 Enter the enable command at the EXEC prompt (>), and then enter a privileged-level password, as follows:

Router> enable

Password:

Router#

Step 2

Step 3

Step 4

Note Before you can save a file to a TFTP server, a file must first exist on the TFTP server. Create this file. Ensure that the filename matches the filename you will copy from the router. Also, ensure that the server permissions are set so the router can copy to this file.

Step 5 Enter the copy startup-config tftp command. The EXEC command interpreter prompts you for the name or interface processor address of the remote host that is to receive the configuration file. (The prompt might include the name or address of a default file server.)

Router# copy startup-config tftp

Remote host []?