Cisco Systems 7507 quick start Install Power Supplies in the Router, Install the Hardware

Install the Hardware

Install Power Supplies in the Router

tive
allation	DC
	FAIL
	AC
ew	POWER

I

0

This procedure applies to AC-input and DC-input power supplies, with differences clearly noted. Do not mix AC-input and DC-input power supplies in the same chassis. Install the first power supply in the lower power supply bay and the second, if any, in the upper bay. In systems with dual power supplies and

separate available power sources, connect each power supply to separate input lines—the second power source will likely be available during a failure.

Step 1 For AC-input power supplies, confirm that the power on the power supply is off.

For DC-input power supplies, turn off the circuit breaker to which you will connect power, and tape the breaker switch to the off position.

Step 2 Hold the power supply by the handle and place your other hand underneath it.

Caution Use two hands to remove and install power supplies.

Step 3 Place the power supply inside the bay, and align it to go straight into the bay.

Step 4 Push the power supply back into the bay until its front panel is flush with the chassis rear panel.

11