Chapter4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
4-14
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
OL-10008-01
PC Port
Configuration
(applies to 7911G
only)
Speed and duplex of the access
port (labeled 10/100 PC). Valid
values:
•Auto Negotiate
•10 Half—10-BaseT/half
duplex
•10 Full—10-BaseT/full duplex
•100 Half—100-BaseT/half
duplex
•100 Full—100-BaseT/full
duplex
If the phone is connected to a
switch, configure the port on the
switch to the same speed/duplex as
the phone, or configure both to
auto-negotiate.
If you change the setting of this
option, you must change the SW
Port Configuration option to the
same setting.
1. Unlock network configuration options.
2. Scroll to the PC Port Configuration
option and then press the Edit softkey.
3. Scroll to the setting that you want and
then press the Select softkey.
4. Press the Save softkey.
PC VLAN
(applies to 7911G
only)
Allows the phone to work better
with non-Cisco switches. Strips the
802.1P/Q tags from the packets
going to a PC from the access port
on the phone. The Admin. VLAN
ID must be set before you can
change this option.
1. Unlock network configuration options.
2. Make sure the Admin. VLAN ID option is
set.
3. Scroll to the PC VLAN option, press the
Edit softkey, and then enter a new PC
VLAN setting.
4. Press the Vali dat e softkey and then press
the Save softkey.
Table4-2 Network Configuration Menu Options (continued)
Option Description To Change