3-3
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
OL-10008-01
Chapter3 Setting Up the Cisco Unified IP Phone
Before You Begin
Cisco Unified CallManager Configuration
The Cisco UnifiedIP Phone requires Cisco Unified CallManager to handle call
processing. Refer to Cisco UnifiedCallManager Administration Guide or
context-sensitive help in the CiscoUnified CallManager application to ensure
that Cisco Unified CallManager is set up properly to manage the phone and to
properly route and process calls.
If you plan to use auto-registration, verify that it is enabled and properly
configured in Cisco UnifiedCallManager before connecting any
Cisco UnifiedIP Phone to the network. For information about enabling and
configuring auto-registration, refer to CiscoUnified CallManager Administration
Guide. Also, see the “Adding Phones to the CiscoUnified CallManager
Database” section on page 2-11.
You must use CiscoUnified CallManager to configure and assign features to the
Cisco Unified IP Phones. See the “Telephony Features Available for the Phone”
section on page 5-2 for details.
In Cisco UnifiedCallManager, you can add users to the database and associate
them with specific phones. In this way, users gain access to web pages that allow
them to configure items such as call forwarding, speed dialing, and voice
messaging system options. See the “Adding Users to CiscoUnified CallManager”
section on page 5-16 for details.
Safety
Review the following warnings before installing the
Cisco UnifiedIP Phones 7906G and 7911G. To see translations of these
warnings, refer to the Regulatory Compliance and Safety Information for the
Cisco Unified IP Phone 7900 Series document that accompanied this device.
Warning
Read the installation instructions before connecting the system to the power
source.
Statement 1004
Warning
Only trained and qualified personnel should be allowed to install or replace this
equipment.
Statement 49