Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system.
Would you like to enter the initial configuration dialog? [yes/no]: y
At any point you may enter a question mark '?' for help.
Use
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: n
First, would you like to see the current interface summary? [yes]: y
Any interface listed with OK? value "NO" does not have a valid configuration
Interface | OK? | Method | Status | Protocol | |
GigabitEthernet0/0/0 | unassigned | NO | unset | down | down |
GigabitEthernet0/0/1 | unassigned | NO | unset | down | down |
GigabitEthernet0/0/2 | unassigned | NO | unset | down | down |
GigabitEthernet0/0/3 | unassigned | NO | unset | down | down |
GigabitEthernet0 | unassigned | YES | unset | administratively down down | |
Configuring global parameters:
Enter host name [Router]:
The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration.
Enter enable secret: test
The enable password is used when you do not specify an
enable secret password, with some older software versions, and some boot images.
Enter enable password: tests
The virtual terminal password is used to protect access to the router over a network interface. Enter virtual terminal password: test Configure SNMP Network Management? [yes]: n Configure IP? [yes]: y
Configure RIP routing? [no]: Configure bridging? [no]: Configure CLNS? [no]:
Configuring interface parameters:
Do you want to configure GigabitEthernet0/0/0 interface? [yes]: n
Do you want to configure GigabitEthernet0/0/1 interface? [yes]: n
Do you want to configure GigabitEthernet0/0/2 interface? [yes]: n
Do you want to configure GigabitEthernet0/0/3 interface? [yes]: n
Do you want to configure GigabitEthernet0 interface? [no]: n
The following configuration command script was created:
hostname Router
enable secret 5 $1$6r./$U5wHcV3uRWkKWK/fap474.
25
