Cisco Systems ASR 1004 quick start Led

–Make certain that each shared port adapter is firmly seated in its subslot and its captive screws are securely tightened.

–The Cisco ASR1000-ESP10 forwarding processor in the Cisco ASR 1004 router is inserted in slot F0, is firmly seated in its slot, and its captive screws are securely tightened.

–All network interface cables are connected.

–The console terminal is turned on.

Step 2 Turn on power. The green OK LED on the power supply turns on.

Step 3 Listen for the fans; you should immediately hear them operating.

Step 4 During the boot process, observe the power LEDs. The power LED should be green on all boards. The Status LED lights yellow to indicate booting and then green when IOS is running.

Table 1 provides information about the LEDs as the system starts.

Table 1		Cisco ASR 1004 Router LED Activity
No.	LED Label		LED	Color	In the Power Up State -Behavior Description
1	PWR		Power	Solid green	All power requirements are within specification
				Off	Off, the router is in standby mode.
2	STAT		System status	Solid green	Cisco IOS has successfully booted.
				Yellow	BOOT ROM has successfully loaded.
				Red	System failure.
3	ACTV		Active	Green	Lit when this is the active ASR 1000 Series RP1.
4	STBY		Standby	Yellow	Lit when this is the standby ASR 1000 Series RP1.
5	CRIT		Critical	Solid Red	Critical alarm indicator. This is on at power up,
					turned off by software.
6	MAJ		Major	Solid Red	Major alarm indicator.
7	MIN		Minor	Amber	Minor alarm indicator.
8	ACO		One Alarm cutoff switch.	Button	When you press this button an interrupt is
					generated informing software that the audible
					alarm relays will be disabled. This interrupt
					generates to both processors.
9	DISK HD		Internal Hard Drive LED	Flashing Green	Activity indicator.
				Off	No activity.
10	DISK USB		External Compact FLASH	Flashing Green	Activity indicator.
			LED
				Off	No activity.
11	DISK BF		Internal Compact FLASH	Flashing Green	Activity indicator.
			(BootDisk) LED
				Off	No activity.

Note The system boots differently depending on the configuration that ships with your system. Example one in this section shows the system being booted from ROMMON with an image all ready resident as the first image in bootflash. The display below is a snapshot of messages that are output on the console of the Cisco ASR 1004 Router system after power-up and during IOS booting.

Step 5 Observe the initialization process. When the system boot is complete (a few seconds), the Cisco ASR 1000 Series RP1 begins to initialize. The console screen displays a script and system banner similar to the following:

rommon 1 > rommon 1 > boot

21