Cisco Systems CIVS-IPC-2600 manual Action Explanation

Chapter 2 Getting Started

Installing the Cisco Video Surveillance IP Camera

Warning The power supply must be placed indoors. Statement 331

Note If you use the IP camera outdoors, place the camera and the power supply in a suitable NEMA enclosure.

Warning This product requires short-circuit (overcurrent) protection, to be provided as part of the building installation. Install only in accordance with national and local wiring regulations. Statement 1045

Warning This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source or an IEC60950 compliant limited power source. Statement 353

Warning The plug-socket combination must be accessible at all times, because it serves as the main disconnecting device. Statement 1019

Caution Inline power circuits provide current through the communication cable. Use a minimum 24AWG communication cable.

To install the IP camera, follow the steps in Table 2-1. For illustrations of the connectors and ports that the steps refer to, see the “IP Camera Overview” section on page 1-2.

.
Table 2-1	Installing the IP Camera
	Action	Explanation
Step 1	Attach a lens to the lens opening on the IP camera.	• If you are using a CS mount lens, screw the lens into
		the lens opening. The IP camera accepts CS-mount
		lenses with a lens protrusion of up to 5 mm.
		• If you are using a C mount lens, screw the C mount
		lens adapter that is supplied with the IP camera into
		the lens opening, then screw the lens into the adapter.
		Ensure that the lens is clean because any dirt may degrade
		the quality of video images.
		Note Save the lens opening dust cap and replace the dust
		cap if you remove the lens.
Step 2	If you are using a DC auto iris lens, connect its cable to	For best performance, Cisco recommends that you use a
	the DC auto iris lens connector on the IP camera.	DC auto iris lens.

Cisco Video Surveillance 2600 IP Camera User Guide

2-2 OL-24127-02