Cisco Systems CIVS-IPC-2600 manual PTZ RS-485 Window, Port Settings, Preset Position

Chapter 3 Configuring and Managing the IP Camera

Applications Windows

PTZ (RS-485) Window

The PTZ (RS-485) window allows you to enable pan, tilt, zoom (PTZ) functions for the IP camera. These functions require that the IP camera be installed with a motorized zoom/focus lens in a pan/tilt mount that supports the Pelco D protocol.

This window also provides options for configuring a patrol sequence, or sequence, for the IP camera. A sequence consists of up to 20 steps, each of which causes the camera to move to a designated position and remain in the position for 30 seconds.

To display the PTZ (RS-485) window, access the configuration windows as described in the “Accessing the IP Camera Windows” section on page 2-6, click Applications, then click PTZ (RS-485).

If you change any options in the PTZ (RS-485) window, you must click Save to save the changes. To discard the changes, click Cancel before clicking Save. These buttons appear at the bottom of the window. You may need to scroll down to see them.

Table 3-20describes the options in the PTZ (RS-485) window.

Table 3-20	PTZ (RS-485) Window Options
Option		Description
Enable External PTZ		Check this check box to enable configuration of the PTZ settings.
Port Settings
Baud Rate		Choose the Baud rate value that is configured on the device that controls the
		PTZ functions of the IP camera.
Data Bits		Choose the data bits value that is configured on the device that controls the
		PTZ functions of the IP camera.
Parity		Choose the parity value that is configured on the device that controls the PTZ
		functions of the IP camera.
Stop Bits		Choose the stop bits value that is configured on the device that controls the
		PTZ functions of the IP camera.
Address		Enter the logical address of the external PTZ device.
		To determine this address, refer to the documentation for the device.
Preset Position
Note The Preset Position option appears if you check the Enable External PTZ check box.

Set Preset Position

Click the Set Preset Position button to define a preset position of the IP camera.

When you click this button, the Set Pan/Tilt window appears. For detailed information about this window, see the “Preset Positions Window” section on page 3-36.

	Cisco Video Surveillance 2600 IP Camera User Guide
OL-24127-02		3-35