Cisco Systems IE301024TC manual AC 5 A, DC 15 A Statement

Chapter 3 Power Supply Installation

Power-Supply Module Installation

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than:

AC: 5 A, DC: 15 A Statement 1005

Warning A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 1022

Warning Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 1030

Warning Hazardous voltage or energy may be present on power terminals. Always replace cover when terminals are not in service. Be sure uninsulated conductors are not accessible when cover is in place. Statement 1086

Step 1 Locate the AC and DC circuit breakers, turn them OFF, and tape them in the OFF position.

Note Do not connect the switch to a power source that has an ON/OFF switch.

Step 2 Use a Phillips screwdriver to loosen the captive screw on the power-input terminal, and open the cover.

Figure 3-9 Opening the Power-Input Terminal Cover

Cisco CGS 2520

100-
240V~, 50-
		60Hz, 2A	100-
			240V~, 50-
				60Hz, 2A
	5	2A
			5
				2A
		10A
				10A

207426

The terminal screws labels are on the power-input terminal cover. See Figure 3-10.

Cisco IE 3010 Switch Hardware Installation Guide

3-8 78-19581-02