E3 Back Cards, BC-UAI-3-T3 Faceplate | Cisco Systems IGX 8400

UXM-E Interface Cards

Figure 4-14 BC-UAI-3-T3 Faceplate

UAI 3T3

R LOC Y REM G OK

TX

P

O

R

T

1

RX

R LOC Y REM G OK

TX

P

O

R

T

2

RX

R LOC Y REM G OK

TX

P

O

R

T

3

RX

RLOC Y REM G OK

TX

P

O

R

T

2

RX

FAIL

ACTIVE

H11700

E3 Back Cards

The E3 back cards for the UXM-E are the six-port BC-UAI-6-E3 and the three-port BC-UAI-3-E3. These cards have six and three pairs of SMB connectors, respectively. Each line has a tri-color LED whose color indicates its status. Each card also has a red Fail LED and a green Active LED to indicate the status of the card. Table 4-14lists the connectors and LEDs. Figure 4-15show the six-port card. Figure 4-16shows the three-port card. For technical data on E3 lines, see the appendix “System Speciﬁcations.”

4-28Cisco IGX 8400 Series Reference

Image 28

Cisco Systems IGX 8400 manual E3 Back Cards, BC-UAI-3-T3 Faceplate

Contents

Trunk Cards Trunk Interface Cards Trunk Front Cards Card Acronym Card Name Trunk Operating Modes Trunk Card MaintenanceLoopback Test Introduction to the UXM-E Trunk Mode Universal Switching Module Enhanced Determining the UXM-E’s Mode of Operation Example Networks with UXM-Es UXM-E Trunk Features UXM-Es in a Network with Heterogeneous Trafﬁc Back Cards for the UXM-E UXM-E InterfacesCard Name Card Description UXM-E Front Card Switchover to a Redundant UXM-E Maximum Number of UXM-EsCabled UXM-E Redundancy UXM-E Status LEDs Fail Active Standby Status of Card Card Mismatch Cellbus Bandwidth UsageUXM-E as a Clock Source Planning for Cellbus Bandwidth Allocation OC3 Calculating Cellbus Bandwidth Changes ATM Across a Public ATM Network UXM-E in Trunk Mode Routing over Cell Trunks OnlyTypes of Supported Trafﬁc Trafﬁc from FastPacket-Based Cards Trafﬁc Type Types of Connections on a UXM-E Trunk Inverse Multiplexing over ATM on IGX Trunks Adding an IGX Feeder Adding and Removing IMA Group Links Line Redundancy IMA Protocol Two-Segment ConnectionsRouting Feeder Connection Cell Endpoint a Endpoint B Type Gateway Type Routing Load Type Three-Segment Connections Feeder Connection Cell Endpoint a Endpoint B TypeRT-VBR Gwtypenone ABR.FST Gwtypenone UXM-E Atfr Activation and Conﬁguration of a UXM-E in Trunk ModeOC3 STM1 SMF 20Cisco IGX 8400 Series Reference Alarms for Physical Lines and Logical Trunks SCR and PCR Policing at Less than 50 CPS on UXM-EBXM IGX-UXM-E Trunk Statistics for Troubleshooting 10 PCR Policing Application Example Summary Statistics UXM-E Interface Cards Connector/Indicator Function Connectors and LEDs for SMF and MMF Back CardsOC-3/STM1 Back Cards 11 BC-UAI-4-155-SMF Faceplate T3 Back Cards 12 BC-UAI-2-155-SMF Faceplate Connectors/Indicator Function Connectors and LEDs for BC-UAI-6-T3 and BC-UAI-3-T3BC-UAI-6-T3 Faceplate E3 Back Cards 14 BC-UAI-3-T3 Faceplate Connectors and LEDs for BC-UAI-6-E3 and BC-UAI-3-E3 BC-UAI-6-E3 Faceplate T1 Back Cards 16 BC-UAI-3-E3 Faceplate BC-UAI-8-T1-DB-15 Faceplate E1 Back Cards 18 BC-UAI-4-T1-DB-15 Faceplate BC-UAI-8-E1 DB-15 Faceplate Port 21 BC-UAI-4-E1 DB-15 Faceplate 22 BC-UAI-4-E1 BNC Faceplate NTM Status Cable Redundancy for the NTMNetwork Trunk Module T1 Interface Card BC-T1 BC-T1 Faceplate Description 23 BC-T1 Faceplate BC-T1 Connections and Status LEDs E1 Interface Back Card BC-E1 BC-E1 Connections and Status LEDs RX-TX Subrate Interface Card BC-SR Connection/Indicator Function BC-SR Connections and Status LEDs Y1 Interface Back Card BC-Y1 RX MON BC-Y1 Connections and Status LEDsTX MON 46Cisco IGX 8400 Series Reference