Cisco Systems IGX 8400 - page 45

Trunk Cards 4-45

Network Trunk Module

Figure 4-26 BC-Y1 Faceplate

Table4-21 BC-Y1 Connections and Status LEDs

Connector/Indicator Function

Y1 Trunk input/output DB-15 connector for Y1 trunk

Line in Y1 trunk input line

Line out Y1 trunk output line

RX MON BNC test connector for monitoring receive Y1 line

TX MON BNC test connector for monitoring transmit Y1 line

LOS light (red) Indicates loss of signal at the local end

Red alarm light (red) Indicates loss of local frame alignment

Yellow alarm light (yellow) Indicates loss of frame alignment at the remote end

AIS light (green) Indicates the presence of all ones on the line

Fail light (red) Indicates an error occurred. First, reset the card with resetcd f. If the

LED comes on again, contact the TAC through Customer Engineering

Active light (green) The card is in service and has active circuits

BC-Y1

LOS (red)

Red alarm (red)

Yellow alarm (yellow)

AIS (green)

Fail (red)

Active (green)

RXMON - monitor jack

Y1 trunk input/output

TXMON - monitor jack

H8319

Line in

Line out

Contents

Main Trunk Cards Trunk Interface Cards This section describes the IGX trunks. The card groups are: Trunk Operating Modes Trunk Card Maintenance Common Alarms, Controls, and Indicators Universal Switching Module Enhanced Introduction to the UXM-E Trunk Mode Determining the UXM-Es Mode of Operation Example Networks with UXM-Es UXM-E Trunk Features UXM-E Interfaces Page Maximum Number of UXM-Es Y-Cabled UXM-E Redundancy Switchover to a Redundant UXM-E Card Mismatch The UXM-E as a Clock Source Cellbus Bandwidth Usage Planning for Cellbus Bandwidth Allocation Calculating Cellbus Bandwidth Changes UBUs fps 2 -------- cps+ 4000 Routing over Cell Trunks Only The UXM-E in Trunk Mode Types of Supported Trafc Types of Connections on a UXM-E Trunk Inverse Multiplexing over ATM on IGX Trunks Page Page Page Activation and Conguration of a UXM-E in Trunk Mode Page Alarms for Physical Lines and Logical Trunks SCR and PCR Policing at Less than 50 CPS on UXM-E Trunk Statistics for Troubleshooting UXM-E Interface Cards Page Trunk Cards 4-25 Figure 4-11 BC-UAI-4-155-SMF Faceplate H11697 R LOC Y REM G OK Figure 4-12 BC-UAI-2-155-SMF Faceplate T3 Back Cards R LOC Y REM G OK Trunk Cards 4-27 Table4-13 Connectors and LEDs for BC-UAI-6-T3 and BC-UAI-3-T3 H11699 Figure 4-13 BC-UAI-6-T3 Faceplate Figure 4-14 BC-UAI-3-T3 Faceplate E3 Back Cards Trunk Cards 4-29 Table4-14 Connectors and LEDs for BC-UAI-6-E3 and BC-UAI-3-E3 H11701 Figure 4-15 BC-UAI-6-E3 Faceplate Transmit Jack BNC connector for transmit data. Receive Jack BNC connector for receive data. T1 Back Cards Trunk Cards 4-31 Table4-15 Connectors and LEDs for BC-UAI-8-T1-DB-15 and BC-UAI-4-T1-DB-15 H11703 Figure 4-17 BC-UAI-8-T1-DB-15 Faceplate Four or eight DB-15s Each DB-15 connector carries transmit and receive data. Trunk Cards 4-33 Table4-16 Connectors and LEDs for BC-UAI-8-E1 and BC-UAI-4-E1 H11704 Figure 4-19 BC-UAI-8-E1 DB-15 Faceplate Green (on the tri-color LED) The card is active and in service. PORT 2 RX UAI-8EI BNC TX PORT 8 Trunk Cards 4-35 Figure 4-21 BC-UAI-4-E1 DB-15 Faceplate H11707 Figure 4-22 BC-UAI-4-E1 BNC Faceplate PORT 2 RX UAI-4EI BNC TX H11708 Network Trunk Module