Send document comments to nexus3k-docfeedba ck@cisco.com
2-17
Cisco Nexus 3000 Series Hardware Installation Guide
OL-25338-04
Chapter 2 Installing the Cisco Nexus 3000 Series Switches
Starting the Swit ch
Caution For safety, periodically check the resi stance value of the antistatic strap . The measurement should be
between 1 and 10 megohm (Mohm).
Starting the Switch
This section provides instructions for powering up the Cisco Nexus 3000 Series switch and verifying the
component installation.
Note Do not connect the Ethernet po rt to the LAN until the i nitial switch configuration has been performed.
For instructions on configuring the switch, see the Cisco Nexus 3000 Series CLI configuration guides.
For instructions on connecting to th e console port, see the “Connecting to the Co nsole Port” section on
page 3-2.
Warning
When installing or replacing the unit, the ground connection must always be made first and
disconnected last.
Statement 1046
To power up the switch and verify hardware operation, follow these steps:
Step 1 Verify that empty power supply slots have filler panels installed, the fac eplates of all modules are flush
with the front of the chassis, and the captive screws of the power supplies, fan module, and all expansion
modules are tight.
Step 2 Verify that the power supply and the fan modules are installed.
Note Depending on the outlet receptacle on your power distribution unit, you may need the optional
jumper power cord to connect the switc h to your outlet receptacle. See the “Jumper Power Cord”
section on page C-8.
Step 3 Ensure that the switch is adequately grounded as described in the “Grounding the Switch” section on
page 2-10).
Step 4 If you are installing a switch with an AC power supply, connect the power supply to an AC power source
as follows:
a. Verify that the AC power source is turned off at the circuit breaker.
b. Plug the power cable into the p ower receptacle on the power supp ly.
c. Attach the other en d of the power cable to the AC power source.
d. Turn on the power at the circuit breake r.
e. Verify that the power supply is f unctioning by making sure that the OK LED t urns green and the
FAULT LED is off.