Cisco Systems OL-16066-01 appendix Cpe

Appendix K Router Platform User Interface Reference

SHDSL Policy Page

Table K-22 SHDSL Dialog Box (Continued)

Line Mode	The line mode used by the controller:
	• auto—The controller operates in the same mode as the other line
	termination (2-wire line 0, 2-wire line 1, or 4-wire enhanced). This is the
	default for CPE line termination.
	• 2-wire—The controller operates in two-wire mode. This is the default
	for CO line termination.
	• 4-wire—The controller operates in four-wire mode.
	Note You can select Auto only when you configure the controller as the
	CPE.
Line	Applies only when the Line Mode is defined as 2-wire.
	The pair of wires to use:
	• line-zero—RJ-11 pin 1 and pin 2. This is the default for CO line
	termination.
	• line-one—RJ-11 pin 3 and pin 4.
Exchange Handshake	Applies only when the Line Mode is defined as 4-wire.
	The type of handshake mode to use:
	• [blank]—The handshake mode is not specified. (When deployed, the
	enhanced option is used.) This is the default.
	• enhanced—Exchanges handshake status on both wire pairs.
	• standard—Exchanges handshake status on the master wire pair only.

	User Guide for Cisco Security Manager 3.2
OL-16066-01		K-51