Cisco Systems OL-16066-01 appendix 119

Appendix K Router Platform User Interface Reference

		Console Policy Page
Table K-52	Console Page—Setup Tab (Continued)
Privilege Level		The privilege level assigned to users connected to the console port. Valid
		values range from 0 to 15:
		• 0—Grants access to these commands only: disable, enable, exit, help,
		and logout.
		• 1—Enables nonprivileged access to the router (normal EXEC-mode use
		privileges).
		• 15—Enables privileged access to the router (traditional enable
		privileges).
		Note Levels 2-14 are not normally used in a default configuration, but
		custom configurations can be created by moving commands that are
		normally at level 15 to a lower level and commands that are normally
		at level 1 to a higher level. You can configure the privilege levels of
		commands using the CLI or by defining a FlexConfig.
		Note If you do not define a value, level 1 is assigned by default. This value
		does not appear in the device configuration.
Disable all the EXEC		When selected, disables EXEC sessions over this line. Select this option
sessions to the router		when you want to allow only an outgoing connection on the console. This
via this line		option is useful for keeping the console port free from unsolicited incoming
		data that can tie up the line.
		When deselected, EXEC sessions are enabled on the console port. This is the
		default.
		Note Selecting this option blocks all access to the device via the console
		port.
Exec Timeout		The amount of time (in seconds) that the EXEC command interpreter waits
		to detect user input on the console port. If no input is detected, the line is
		disconnected. Valid values range from 0 to 2147483. The default is 600 (10
		minutes). Setting the value to 0 disables the timeout.
		Note Although the timeout is defined in seconds, it appears in the CLI in
		the format [mm ss].

	User Guide for Cisco Security Manager 3.2
OL-16066-01		K-119