Cisco Systems OL-16066-01 appendix 133

Appendix K Router Platform User Interface Reference

VTY Policy Page

Table K-58	VTY Line Dialog Box—Setup Tab (Continued)
Ending VTY Line		Applies only when configuring a group of lines.
Number		The relative line number of the last VTY line in the group.
		Note When you configure a group of lines, all the lines in the group must
		fall within one of two ranges, 0-4 or 6-15.
Password		The password for accessing this VTY line.
		The password is case sensitive and can contain up to 80 alphanumeric
		characters. The first character cannot be a number. Spaces are not allowed.
		Enter the password again in the Confirm field.
Privilege Level		The privilege level assigned to users on this VTY line. Valid values range
		from 0 to 15:
		• 0—Grants access to these commands only: disable, enable, exit, help,
		and logout.
		• 1—Enables nonprivileged access to the router (normal EXEC-mode use
		privileges).
		• 15—Enables privileged access to the router (traditional enable
		privileges).
		Note Levels 2-14 are not normally used in a default configuration, but
		custom configurations can be created by moving commands that are
		normally at level 15 to a lower level and commands that are normally
		at level 1 to a higher level. You can configure the privilege levels of
		commands using the CLI or by defining a FlexConfig.
		Note If you do not define a value, level 1 is assigned by default. This value
		does not appear in the device configuration.
Disable all the EXEC		When selected, EXEC sessions are disabled over this line. Select this option
sessions to the router		when you want to allow only an outgoing connection on this line. This option
via this line		is useful for keeping a particular line free from unsolicited incoming data
		that can tie up the line.
		When deselected, EXEC sessions are enabled over this line. This is the
		default.

	User Guide for Cisco Security Manager 3.2
OL-16066-01		K-133