Cisco Systems OL-16066-01 appendix Policy. See Http Page-Setup Tab, page K-111, 134

Appendix K Router Platform User Interface Reference

VTY Policy Page

Table K-58	VTY Line Dialog Box—Setup Tab (Continued)
Exec Timeout		The amount of time (in seconds) that the EXEC command interpreter waits
		to detect user input on the line. If no input is detected, the line is
		disconnected. Valid values range from 0 to 2147483. The default is 600 (10
		minutes). Setting the value to 0 disables the timeout.
		Note Although the timeout is defined in seconds, it appears in the CLI in
			the format [mm ss].
Input Protocols		The protocols that you can use for incoming connections on this line:
		• All—All supported protocols are permitted. Supported protocols
		include LAT, MOP, NASI, PAD, rlogin, SSH, Telnet, and V.120.
		• None—No protocols are permitted. This makes the port unusable by
		incoming SSH, Telnet, and rlogin connections.
		Note Setting the input protocols setting to None might prevent Security
			Manager from connecting to the device after deployment. The device
			can still be managed using SSL, if SSL is enabled in the HTTP
			policy. See HTTP Page—Setup Tab, page K-111.
		• Protocol—Enables one or more of the following protocols:
		–	SSH—Secure Shell protocol.
		– Telnet—Standard TCP/IP terminal emulation protocol.
		–	rlogin—UNIX rlogin protocol.
		Note SSH and rlogin require that you configure AAA authentication. See
			VTY Line Dialog Box—Authentication Tab, page K-136.
		Note Not all IOS Software Versions support rlogin as an input protocol.

	User Guide for Cisco Security Manager 3.2
K-134	OL-16066-01