Manuals / Cisco Systems / Computer Equipment / Switch

Cisco Systems OL-16447-01 Installing and Removing SFP Modules, Table- or Shelf-Mounting, 2-19

Models: OL-16447-01

1 102
Download 102 pages 41.83 Kb
Page 45
Image 45
Table- or Shelf-Mounting

Chapter 2 Switch Installation

Installing and Removing SFP Modules

•Connect to the front-panel ports. See the “Connecting to the 10/100 and 10/100/1000 Ports” section on page 2-22, the “Connecting to Fiber-Optic SFP Modules” section on page 2-24, and the “Connecting to 1000BASE-T SFP Modules” section on page 2-25to complete the installation.

For configuration instructions about using the CLI setup program, go to Appendix C, “Configuring the Switch with the CLI-Based Setup Program.”

Table- or Shelf-Mounting

Follow these steps to install the switch on a table or a shelf:

Step 1 Place the switch on a table or a shelf near an AC-power source.

Step 2 After the switch is placed on the table or shelf, you need to do these tasks to complete the installation:

•Power on the switch. See the “Verifying Switch Operation” section on page 2-5.

•Connect to a 10/100 port or to the RJ-45 connector of a dual-purpose port, and run the initial configuration dialog. See the Cisco ME 3400E Ethernet Access Switch Getting Started Guide for instructions.

•Connect to the front-panel ports. See the “Connecting to the 10/100 and 10/100/1000 Ports” section on page 2-22, the “Connecting to Fiber-Optic SFP Modules” section on page 2-24, and the “Connecting to 1000BASE-T SFP Modules” section on page 2-25to complete the installation.

For configuration instructions about using the CLI setup program, go to Appendix C, “Configuring the Switch with the CLI-Based Setup Program.”

Note When the connectors are not being used, replace the dust covers on them for protection.

Installing and Removing SFP Modules

Installing SFP Modules

Figure 2-16shows an SFP module that has a bale-clasp latch.

Caution We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached because of the potential damage to the cables, the cable connector, or the optical interfaces in the SFP module. Disconnect all cables before removing or installing an SFP module.

Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP modules more often than is absolutely necessary.

 

 

Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide

 

 

 

 

 

 

OL-16447-01

 

 

2-19

 

 

 

 

 

Page 44 Page 46
Page 45
Image 45
Cisco Systems OL-16447-01 Installing and Removing SFP Modules, Table- or Shelf-Mounting, Installing SFP Modules, 2-19
Page 44 Page 46