Cisco Systems OL-16447-01 manual Connecting to Fiber-Optic SFP Modules

Chapter 2 Switch Installation

Connecting to Fiber-Optic SFP Modules

Connecting to Fiber-Optic SFP Modules

Warning Class 1 laser product. Statement 1008

Caution Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables from contamination and ambient light.

Before connecting to the SFP module, be sure that you understand the port and cabling stipulations in the “Installation Guidelines” section on page 2-4and in the “SFP Modules” section on page 1-5. See Appendix B, “Connector and Cable Specifications,” for information about the LC on the SFP module.

Step 1 Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use. Step 2 Insert one end of the fiber-optic cable into the SFP module port (see Figure 2-22).

Figure 2-22 Connecting to a Fiber-Optic SFP Module Port

280849

Step 3 Insert the other cable end into a fiber-optic connector on a target device.

Step 4 Observe the port status LED.

The LED turns green when the switch and the target device have an established link.

The LED turns amber while the STP discovers the network topology and searches for loops. This process takes about 30 seconds, and then the port LED turns green.

If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be problem with the adapter installed in the target device. See Chapter 4, “Troubleshooting,” for solutions to cabling problems.

Step 5 If necessary, reconfigure and restart the switch or target device.

	Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
2-24	OL-16447-01