Chapter 2 Switch Installation

Connecting to Dual-Purpose Ports

Connecting to Dual-Purpose Ports

Step 1 Insert an RJ-45 connector or an SFP module in the port. See Figure 2-24.

For more information about RJ-45 connectors and SFP modules, see the “Connecting to the 10/100 and 10/100/1000 Ports” section on page 2-22and the “Connecting to Fiber-Optic SFP Modules” section on page 2-24.

Figure 2-24 Connecting to a Dual-Purpose Port

280949

Step 2 Connect the other end of the cable to the other device. The switch automatically detects the connection and configures the port.

By default, the switch detects that either an RJ-45 copper connector or a fiber-optic SFP module in a dual-purpose port and configures the port accordingly. You can change this setting and configure the port to recognize only an RJ-45 connector or only an SFP module by using the media type interface configuration command. For more information, see the switch command reference.

Where to Go Next

You can use the default configuration or use any of the management options described in the “Management Options” section on page 1-15to change the switch settings.

 

Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide

2-26

OL-16447-01

Page 52
Image 52
Cisco Systems OL-16447-01 manual Connecting to Dual-Purpose Ports, Where to Go Next