22-3
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter22 DLPs A500 to A599
DLP- A509 Provision CE-1000-4 Ethernet Ports
DLP-A509 Provision CE-1000-4 Ethernet Ports
Note You can provision SONET contiguous concatenated (CCAT) or virtual concatenated (VCAT) circuits for
the CE-1000-4 before or after provisioning the card’s Ethernet ports and/or packet-over-SONET (POS)
ports. See the “NTP-A257 Create an Automatically Routed Optical Circuit” procedure on page6-38 or
the “NTP-A264 Create an Automatically Routed VCAT Circuit” procedure on page 6-82, as needed.
Step1 In node view, double-click the CE-1000-4 card graphic to open the card.
Step2 Click the Provisioning > Ether Ports tabs.
Step3 For each CE-1000-4 port, provision the following parameters:
•Port Name— If you want to label the port, enter the port name.
•Admin State— Select the service state for the port. See the “DLP-A214 Change the Service State
for a Port” task on page19-9 for more information.
•Flow Control— Select the flow control for the port. Possible values are None, Symmetrical, and
Pass Through.
•Auto Negotiation— Click this check box to enable autonegotiation on the port (default). If you do
not want to enable autonegotiation control, uncheck the box.
•MTU— If you want to permit the acceptance of jumbo size Ethernet frames, choose 10004(default).
If you do not want to permit jumbo size Ethernet frames, choose 1548.
•Watermark— Select the flow control watermark for the port. To provision the Low Latency flow
control watermark, choose Low Latency from the drop-down list. The Flow Ctrl Lo and Flow Ctrl
Hi values change. To provision a Custom flow control watermark, choose Custom from the
drop-down l ist. Ente r values in the Flow Ctr l Hi and Fl ow Ctrl Lo c olumns. T he Flow Ctr l Lo value
has a valid range from 1 to 510 and the Flow Ctrl Hi value has a valid range from 2 to 511. The Flow
Ctrl Lo value must be lower than the Flow Ctrl Hi value.
Step4 Click Apply.
Step5 Refresh the Ethernet statistics:
a. Click the Performance > Ether Ports > Statistics tabs.
b. Click Refresh.
Note Reprovisioning an Ethernet port on the CE-1000-4 card does not reset the Ethernet statistics for
that port.
Step6 Return to your originating procedure (NTP).
Purpose This task provisions CE-1000-4 Ethernet ports to carry traffic.
Tools/Equipment None
Prerequisite Procedures DLP-A60 Log into CTC, page 17-69
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher