Cisco Systems ONS 15454 manual DLP-A538 Add a Tarp Manual Adjacency Table Entry, 22-44

Chapter 22 DLPs A500 to A599

DLP- A537 Remove a Static TID to NSAP Entry from the TARP Data Cache

DLP-A537 Remove a Static TID to NSAP Entry from the TARP Data Cache

	Purpose	This task removes a static TID to NSAP entry from the TDC.
	Tools/Equipment	None
	Prerequisite procedures	DLP-A60 Log into CTC, page 17-69
	Required/As needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioner or higher
Step 1	In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 2	Click the static entry that you want to delete.
Step 3	Click Delete Static Entry.
Step 4	In the Delete TDC Entry dialog box, click Yes.
Step 5	Return to your originating procedure (NTP).

DLP-A538 Add a TARP Manual Adjacency Table Entry

Purpose	This task adds an entry to the TARP manual adjacency table (MAT). Entries
	are added to the MAT when the ONS 15454 must communicate across
	routers or non-SONET NEs that lack TARP capability.
Tools/Equipment	None
Prerequisite procedures	DLP-A60 Log into CTC, page 17-69
Required/As needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 In the node view, click the Provisioning > OSI > TARP > MAT tabs.

Step 2 Click Add.

Step 3 In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:

•Level—Sets the TARP Type Code that will be sent:

–Level 1—Indicates that the adjacency is within the same area as the current node. The entry generates Type 1 PDUs.

–Level 2—Indicates that the adjacency is in a different area than the current node. The entry generates Type 2 PDUs.

•NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter the address in the Masked NSAP Entry dialog box.

	Cisco ONS 15454 Procedure Guide, R7.0
22-44	November 2007