22-34
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter22 DLPs A500 to A599
DLP- A533 Create Ethernet RMON Alarm Thresholds
DLP-A533 Create Ethernet RMON Alarm ThresholdsNote The ONS 15454 ML-Series cards use the Cisco IOS CLI to manage RMON.
Step1 Complete the DLP-A60 Log into CTC, page 17-69 at the node where you want to set up RMON. If you
are already logged in, continue with Step 2.
Step2 Double-click the Ethernet card where you want to create the RMON alarm thresholds.
Step3 In card view, click the Provisioning > RMON Thresholds tabs.
Note For CE- and ML-Series Ethernet cards, click the Provisioning > Ether Ports > RMON
Thresholds tabs or Provisioning > POS Ports > RMON Thresholds tabs.
Step4 Click Create.
The Create Ether Threshold dialog box appears (Figure22-11).
Figure22-11 Creating RMON Thresholds
Step5 From the Port drop-down list, choose the applicable port on the Ethernet card you selected.
Step6 From the Variable drop-down list, choose the variable. See Table 22-6 and Table22-7 for a list of the
Ethernet and POS threshold variables available in this field.
Purpose This procedure sets up remote monitoring (RMON) to allow network
management systems to monitor Ethernet ports.
Tools/Equipment None
Prerequisite Procedures NTP-A323 Verify Card Installation, page 4-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher