22-49
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter22 DLPs A500 to A599
DLP- A543 Remove a TARP Manual Adjacency Table Entry
Step5 Provision the other tunnel end point using the documentation.
Step6 Return to your originating procedure (NTP).
DLP-A543 Remove a TARP Manual Adjacency Table Entry
Caution If TARP manual adjacency is the only means of communication to a group of nodes, loss of visibility
will occur when the adjacency table entry is removed.
Step1 In node view, click the Provisioning > OSI > TARP > MAT tabs.
Step2 Click the MAT entry that you want to delete.
Step3 Click Remove.
Step4 In the Delete TDC Entry dialog box, click OK.
Step5 Return to your originating procedure (NTP).
DLP-A544 Change the OSI Routing Mode
Caution Do not complete this procedure until you confirm the role of the node within the network. It will be either
an ES, IS Level 1, or IS Level 1/Level 2. This decision must be carefully considered. For additional
information about OSI provisioning, refer to the “Management Network Connectivity” chapter of the
Cisco ONS 15454 Reference Manual.
Caution LSP buffers must be the same at all NEs within the network, or loss of visibility could occur. Do not
modify the LSP buffers unless you are sure that all NEs within the OSI have the same buffer size.
Purpose This task removes an entry from the TARP manual adjacency table.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the OSI routing mode.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher