22-43
Cisco ONS 15454 Procedure Guide, R7.0
November 2007
Chapter22 DLPs A500 to A599
DLP- A536 Add a Static TID to NSAP Entry to the TARP Data Cache
•T2—Sets the amount of time to wait for a response to a Type 2 PDU. TARP Type 2 PDUs seek a
specific NE TID value within OSI Level 1 and Level 2 areas. The default is 25 seconds. The range
is 0 to 3600 seconds.
•T3—Sets the amount of time to wait for an address resolution request. The default is 40 seconds.
The range is 0 to 3600 seconds.
•T4—Sets the amount of time to wait for an error recovery. This timer begins after the T2 timer
expires without finding the requested NE TID. The default is 20 seconds. The range is
0 to 3600 seconds.
Note The T1, T2, and T4 timers are not used if TARP PDUs Origination is not enabled.
Step3 Click Apply.
Step4 Return to your originating procedure (NTP).
DLP-A536 Add a Static TID to NSAP Entry to the TARP Data CacheStep1 In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step2 Click Add Static Entry.
Step3 In the Add Static Entry dialog box, enter the following:
•TID—Enter the TID of the NE. (For ONS nodes, the TID is the Node Name parameter on the node
view Provisioning > General tab.)
•NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Step4 Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the
Add Static Entry dialog box.
Step5 Return to your originating procedure (NTP).
Purpose This task adds a static TID to NSAP entry to the TDC. The static entries are
required for NEs that do not support TARP and are similar to static routes.
For a specific TID, you must force a specific NSAP.
Tools/Equipment None
Prerequisite procedures DLP-A60 Log into CTC, page 17-69
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioner or higher