Chapter 5 TroubleShooting
3 Paper Feed Troubleshooting
Problem |
| Cause and remedy | |
|
|
|
|
Paper doesn't | • | Wrong paper path. | → Use correct path. (See Chapter 3) |
feed. | • | Mechanism head is open. | → Close the mechanism head. |
| |||
Paper skew. | • | Edge of paper is not in | → Slightly push the paper guide to the |
|
| contact with the paper | edge of the paper. |
|
| guide. | (See Chapter 3) |
| • | Roll guide is not in | → Slightly push the roll guide to the roll |
|
| contact with the roll | paper. (See Chapter 3) |
|
| paper. |
|
| • Head pressure is not | → Adjust it with the offset adjustment | |
|
| correct. | screw according to the width of the |
|
|
| paper. (See Chapter 4) |
Paper doesn't | • | Setting mode is not | → Check whether the setting mode is |
align with the print |
| correct. | for paper gap or black line sensor |
position. |
|
| and if it is not, change it. |
|
|
| (See Chapter 2) |
| • Paper gap (black line) | → Adjust the voltage of the paper gap | |
|
| sensor adjustment | or black line sensor from the voltage |
|
| failure. | setting in the system maintenance |
|
|
| mode. |
|
|
| (See Chapter 2) |
|
|
| → If the contents of the transfer data |
| • Transfer data is abnormal. | are incorrect, set them properly | |
| again. | ||
|
|
| |
|
|
|
|
54
