Chapter 4 Printer Adjustments

3Using Narrow Ribbon (Ribbon Tension Adjustments)

If ribbon slips or wrinkles during printing, adjust the ribbon tension.

The printer has already been factory-set to the ribbon width of 114 mm (4.5 in). When you use a different ribbon, adjust the ribbon tension as follows:

1.Hold the ribbon roll by one hand on the side of the knob you operate so that it does not turn.

2.Slightly push the knob to the ribbon roll and turn it until the stopper comes to the desired position.

3.Gradually release the knob so that the stopper fits in the groove on the side of the knob.

Set values to each ribbon width:

*: Factory setting

 

Knob on ribbon

Knob on ribbon

Ribbon width

 

winding section

feeding section

 

 

 

5

5

Adjustments when ribbon slipping occurs

 

 

 

 

 

4

4

25.4 mm (1 in) 50.8 mm (2 in)

 

 

 

 

 

3

3

76.2 mm (3 in)

 

 

 

 

 

2

2

101.6 mm (4 in)

 

 

 

 

 

1*

1*

Adjustments when ribbon wrinkle occurs.

 

 

 

 

4.Perform printing and check for ribbon wrinkle or slipping. If it s occurs, adjust it according to the following procedure:

(a)Ribbon wrinkles: Increase the tension on the ribbon winding section.

(b) Ribbon slips:

Decrease the tension on the ribbon feeding section.

If it is not resolved even when the tension on the ribbon feeding section is set to 5 (Mild), increase the tension on the ribbon winding section.

If ribbon problems are not resolved, consult our service personnel.

Ribbon feeding section

Variable knob

Mild

Ribbon winding section

Strong

Strong

Mild

45

Page 46
Image 46
Citizen CLP-7001, CLP-7401, CLP-7002 Using Narrow Ribbon Ribbon Tension Adjustments, Set values to each ribbon width