Chapter 3. Installation and Maintenance
Figure 3–21 Remove Installed SIMM Modules
CAUTION
Ensure the “side 1” side of the two replacement SIMMs is facing toward you when installing the modules in the following step.
5.Installed the two replacement memory modules by aligning the module and con- nector pins (check alignment guide in center of module) and gently pivot the mod- ule the main controller board until it snaps into place (see Figures
6.Replace the controller into the shelf.
7.Power on the UPS and shelf and check the activity LEDs on the front panel of the controller. The reset switch/LED should begin to flash at a
