Compaq EK-SMCPO-UG. C01 manual Install replacement Simm

3-20RAID Array 3000 Pedestal Storage Subsystem Hardware User’s Guide

5.Installed the two replacement memory modules by aligning the module and connector pins (check alignment guide in center of module) and gently pivot the module the main controller board until it snaps into place (Figures 3–14 and 3–15).

6.Replace the controller into the pedestal.

7.Power on the UPS and pedestal and check the activity LEDs on the front panel of the controller. The reset switch/LED should begin to flash at a half-second rate (heartbeat) and the host activity LEDs should flash.

Figure 3-14. Install replacement SIMM

Figure 3-15. Pivot SIMM down to secure