Maintenance
Removing the Pedestal Door
Proceed as follows to remove the pedestal door (Figure
1.Unlock and open the door to a 90º angle in relation to the closed position.
2.Carefully lift up on the door until the hinge pins are against the top of the mounting holes.
3.Pull the door straight out until the hinge pins clear the bezel.
Figure 3-3. Removing pedestal door
Replacing an SBB
There are two methods for replacing a disk drive SBB with an identical SBB:
■Hot plug – This method requires that the SCSI controller support removing and installing SBBs while the bus is active. Hot plug is supported by the RAID Array 3000 controller
■Cold plug – Requires removing AC power from the pedestal and disabling the UPS to deactivate the bus
Perform the following procedure to replace an SBB in the pedestal (Figure
