Compaq EK-SMCPO-UG. C01 manual List of Figures

	Contents v
Chapter 4
Expansion Pedestal Option
Product Description	4-1
Expansion Pedestal Cabinet	4-2
Expansion Pedestal Components	4-4
Reconfiguring Base Pedestal UltraSCSI Bus	4-6
Chapter 5
Second Controller Option
Second Controller Option Kit	5-2
Installing the Upgrade	5-3
Saving Existing Configuration	5-3
Updating Firmware	5-4
Shutting Down the RA3000	5-6
Installing Two SIMMs into Second Controller	5-7
Replacing Existing Controller	5-8
Restoring the Configuration	5-9
Updating Firmware on Second Controller	5-10
Installing Original Controller	5-11
Configuring a Dual Controller Installation for a Single Serial Port	5-11
Configuring the RA3000 for the Active Mode of Operation	5-12
Configuring the Dual Controllers	5-13
Connecting to Your Dual Controller Storage System	5-14
Verifying the Controller Operating Parameters	5-15

List of Figures

Figure 1-1.	RAID Array 3000 pedestal enclosure (drives optional)	1-2
Figure 1-2.	Pedestal front panel major components	1-6
Figure 1-3.	Pedestal rear panel power supplies	1-6
Figure 1-4.	EMU circuit board location	1-10
Figure 1-5.	Pedestal rear panel components	1-11
Figure 1-6.	UltraSCSI bus port and default SCSI ID assignments	1-12
Figure 1-7.	UltraSCSI bus configuration switch	1-13
Figure 1-8.	Slot locations and SCSI ID addresses	1-13
Figure 1-9.	Single host, single adapter cabling diagram	1-15
Figure 1-10.	Single host, dual adapter/dual controller cabling diagram	1-16
Figure 1-11. Single host, single adapter/dual controller (y-cable
	connection) cabling diagram	1-17
Figure 1-12.	Dual host, single adapter/single controller cabling diagram	1-18
Figure 2-1.	Bridging the gap between the host and the pedestal	2-3
Figure 2-2.	Units created from storagesets, partitions, and disk drives	2-4
Figure 2-3.	Controller front panel	2-9