4. Refer to Figure45.
5. Carefully insert the SDRAM module into the connector.
6. Press strongly on the module until it is fully home.
7. Close the clips 1 by pivoting them in the directions shown by the arrows in the
diagram. Youhear a click when the clips are fully closed. If you cannot close the
clips, the module is not fully home. Press the module fully home, then close the
clips.
8. Reinstall the adapter into the using system (see the Installation and Service Guide
for the using system).
1 1
Figure45. Installing the SDRAM Module
Chapter15. Removal and Replacement Procedures 331