Quest Juice Training Manual
Pump Speed Switch
The pump speed switch has two settings, low and high. For most dispensing situations high speed will be the preferred speed. Most concentrates use this setting. Low speed is only used when the water pres- sure is at the low end of the range (25 PSI or less) and the concentrate is a very thin viscosity such as apple or cranberry. Low speed cuts the output voltage to 18VDC.
Using a water booster system to increase the flowing pressure to the recommended pressure is a better solution.
5.To change the brix setting, simply readjust the water flow rate. Located on each of the valve assemblies inside the refrigerated compartment are the adjusting screws for the water flow rate (one per valve).
If the brix reading is too high or low, rotate the appropriate water flow control according to the diagram below. Repeat steps
Lowers Brix by increasing water
Raises Brix by reducing water
IMPORTANT: When making changes to the water flow control, do not rotate more than 1/4 turn per adjustment. Additionally, prior to taking your next brix reading, “tap” the corresponding dis- pense button several times prior to drawing a sample. This will clear remnant drink from the dis- pense nozzle AND help move the flow control to its new setting.
PROGRAMMING THE PORTION CONTROL
If your dispenser has optional portion controls, they have been
16 ounces. To change the pour sizes, please follow the instructions below:
1.Simultaneously, press and hold “small” and “extra large” push button switches on the Portion Control Module until the “Refill” light starts blinking. Release the switches. The blinking Refill light indicates the programming mode is active.
2.Place the cup under the dispense nozzle and push the selected size button (small, medium, large, or extra large). Hold the button in until the cup fills to the desired portion, then release the button. Repeat the above procedure for the remaining sizes.
3.After programming all the drink sizes, press and release the “cancel/pour” switch to return the Portion Control to the operational mode. The blinking REFILL light will go out.
4.If at a future date it is decided to change the portion size of the drinks, the individual sizes
can be adjusted by the above procedure. It is not necessary to reprogram every size. Additionally the portion control has full memory retention in case of a power failure.
Cancel/Pour Button
To pour a drink without using a
Publication Number: TP00968 | - 8 - | © 2004, IMI Cornelius Inc. |
